1、 Equipment Overview

1. Suitable for manual stamping and forming of aluminum-plastic film for flexible packaging lithium battery cells, with sheet material as the input material;

2. The gas-liquid booster cylinder provides pressure;

3. Manual feeding;

4. Safety light curtain protection;

5. Applicable molds: two-piece mold/spring mold.

2、 Technical parameters

1. Pressure: maximum 20 tons;

2. Machine production capacity: 8~10PPM;

3. The minimum value of Ra shall not be less than 2.0mm; Rb and Rc shall not be less than 0.5mm; a°@4~5°；

4. The H value can be adjusted, but the maximum value may vary depending on the material of the aluminum film, generally reaching 5mm. When the aluminum film is Showa aluminum film, H can reach 6mm without being pulled------ The mold base needs to be customized according to the size requirements of your company's mold drawings;

5. The maximum size of aluminum film is 550x750mm.

6. Equipment installation requirements

(1) Power supply: AC220V; 50Hz； single-phase; 1KW；

(2) Air pressure: 0.5~0.6Mpa standard air pressure;

(3) The external dimensions of the equipment are approximately 1000mm (length) x 900mm (width) x 1800 (height).